LED fluorescent tube installation instructions word solution
2018-05-07 Common Problem

      AC220v-50Hz is AC 220 volts, 50 Hz, 3.0 amps. This is the standard for ordinary home electricity. DC 220v\-50Hz is alternating current 220 volts, 50 Hz direct current.

      ARISE LED double-end conductive LED lamp, contains a professional design of the built-in power supply, direct input voltage AC220V ~ 50HZ, directly installed on the T8 tube for the installation of a dedicated lamp holder, you do not need to add other drivers. Fluorescent tube can be directly replaced. Before the user can take out the original fluorescent tube and install the LED tube, several kinds of electrical equipment on the lamp holder need to be cancelled. Carefully check the configuration of the lamp holder and cut it after power supply. This can be avoided. An accident happened.

      The power cable of the A stand is connected to the external power cable. The two heads can be directly installed without distinguishing the zero fire wire.

      B Built-in power supply Both ends of the input type directly take out the starter, built-in single-end input type directly take out the starter, and connect the starter pin of the wire with the wire, and then insert the LED fluorescent tube.

      C Electronic Ballast: Disconnect the power cord from both ends of the ballast, and then connect the zero fire wire at both ends of the lamp holder. The two heads are indistinguishable from each other.

      D. The traditional analog lamp cannot be directly connected to the power supply. Do not use an inductive ballast type lamp holder. It is suitable for Type C. You can directly remove the original electronic ballast and directly connect the positive and negative poles of the power supply to the two sides of the LED lamp. The original electronic ballasts can be used without or withdrawable. Simply cut the power cords at both ends and connect the power supply to both ends of the LED fluorescent lamp.

Exhibition

Online ServiceClose