Heating radiation area
1*2.4m (2 pieces)
≤175W (heat radiation downward)
25~30cm from the ground, the temperature can reach 32-35℃
Temperature rise 10°C~15°C (20~30cm from the ground)
Warm lamp height requirements
The overall height does not exceed 12 cm (including the protective net)
Temperature requirements on the back of the warm lamp shade
The temperature on the back side does not exceed 60°C (the lower the better), to prevent the high temperature on the back side from igniting the PP material on the back side
High - Low - Off
A protective net needs to be installed at the bottom of the warm lamp
Lamp Life Requirements
Infrared Radiation Conversion Efficiency
High pressure performance
220V can load 120% without being burned
Water jet resistance
It should not burst when it encounters cold water when it is ignited
The temperature rise at both ends of the lamp tube is not higher than 185K
With pressure regulating function
a fixed way
Use a stainless steel spring buckle (safety buckle) with a diameter of about 35mm and an inner diameter greater than 25mm for fixing (installed on the warm lamp)
The distance between two stainless steel spring buckles is: 100mm
☑ High-quality ultra-bright LED light-emitting diodes are used to emit light, which has the characteristics of low power consumption, low heat generation, no glare, long life, and impact resistance. Low voltage DC 12V, 24V power supply, high safety and reliability.
☑ The colors are pure, soft, gorgeous and colorful, including red, yellow, blue, green, white and colorful, and various colors or changes can be customized according to requirements. The full-color effect product can be equipped with a controller, and the three colors and seven colors are interchangeable.
☑ Long life, with an average life of 30,000 hours, maintenance-free.
☑Every six LEDs can form a loop, which can be cut off arbitrarily along the tangent line above without damaging other parts, and can be extended indefinitely, and various lengths of light strips can be customized according to customer requirements.
☑Using a very soft PCB board as the substrate, it can be docked, bent, cut and fixed on the uneven surface at will.
☑ The product is light and thin, suitable for installation in narrow spaces.
☑ It is composed of a printed circuit board with double-sided tape on the back for pasting and attaching to a fixed object.
☑The back of the sleeve is pasted with 3M glue, which can be fixed with buckles or double-sided tape on the back, and the installation methods are diverse.
☑ Waterproof joints, the protection level is up to IP65, suitable for outdoor landscape decoration.
☑Low power, high light efficiency, more energy-saving.